Root wisteria, also known as cormorant wisteria and creeping wisteria, is a vine that grows wild across much of the Midwest and Southeastern parts of the United States. It can be found in the southern part of Iowa, southwest Arkansas, western Illinois, southern Michigan, northern Wisconsin and southern Indiana. Most of the time it’s not too difficult to deal with, however some cases can be very tough to get rid of. You may find it in places you least expect, like around tree stumps and large rocks. If you’re wondering how to root wisteria from cuttings, here’s how:
When cutting down a plant for plant propagation purposes, always make sure you cut at least one side of the stem back, if only to allow for new shoots. Don’t cut all the way to the ground or you’ll end up with a dead plant. Take note though, that cutting too much off the stem will cause the underground stems to die and you’ll have an awful mess on your hands. So, what do you do if you find root blocks in your cuttings?
The best thing to do when dealing with roots is to just dig them out of the ground. However, in this case, you’re going to want to take care. You don’t want to break your roots, or worse, suffocate them by trying to shove them down into the soil. Determining how deep to dig the roots in is important. If you can just go to the edge of the soil and determine how deep you can go, then that would be fine.
Digging how to root wisteria from cuttings is often times hard for some people. Luckily, it doesn’t need to be. You can actually just look for a piece of tissue or paper that has a hole in it. Peel it back so that you can see the roots inside and just stick your hand in there. If you have access to a pot then this should work as well, but if not, then you’re stuck digging through the ground.
Once you’ve gotten the roots out of the soil, then it’s time to take them back to the plant. You’re going to need a pot that’s wide enough for the roots to spread out some more. Once you’ve gotten them to this point, then you’re going to want to put the pot in the sun and just keep it there. This should help get the roots to actually take root into the soil.
After a few days, just remove the pot and dig a hole underneath it. The cuttings will go in with the roots, and you won’t have to worry about them sticking out and rotting in the soil any longer. Just remove them and put them in the hole.
You can also use this same method when learning how to root wisteria from cuttings. Just take a new cutting of wisteria and stick it in the ground, just like you did when learning how to root guava. Then just add water so that the roots can grow into the soil. Just remember that you should only put about one inch worth of soil at a time into the hole, because as the plant grows it can easily over-seed and you’ll end up with more than you wanted.
Once you get the cuttings to this point, just let them go for a year or two. During this time they will completely settle out, and then you can dig them up and plant the new cuttings. The fact that you’re learning how to root wisteria from cuttings is actually a good thing. You should know that because the plant needs to develop roots to get food, it will probably take at least a year or two before the fully developed roots are visible. You might have to do some trimming and repotting during this time, but the process should be fairly easy.
